A professional dry cleaning machine that allows you to clean any surface – textiles, plastic, leather, rubber, etc. – as quickly and efficiently as possible with minimal detergent consumption.
It is recommended to use the universal interior cleaner M-760
Tornador M-2010 allows you to easily clean even the most inaccessible places – air ducts, joints and bends, relief surfaces, etc.
The machine can be used both for localized removal of dirt and for complete dry cleaning of the interior.
The Tornador M-2010 has an integrated pressure control valve, which automatically reduces or increases the volume of the output composition or air, depending on the distance of the nozzle from the treated surface. After treatment, the surface remains practically dry.
Design of the spout
Plastic spout without bearings
Free rotation speed
3000 rpm
Air flow
75 L/min.
Composition consumption
3.6 L/h
Weight
0.67 kg
Фото
The device has two positions:
Supply of composition under air pressure – detergent solution under pressure is supplied to contaminated surface.
Air supply, which allows you to «knock out» dirt from the treated surface – the effect of a «tornado» created by a spinning spout inside the neck of the device. Dirt removed from the surface settles in the neck, which is cleaned by simple immersion in water and air supply.
Technical specifications:
Free rotation speed: 3000 rpm.
Air flow: 75 L/min.
Composition consumption: 3.6 L/h.
Air inlet: 1/4″.
Optimal air pressure: 6.2 bar.
Weight: 0.67 kg.
Instructions and recommendations:
Use only recommended cleaning agents – do not use detergents containing chlorine.
Avoid using excessively high air pressure – pressures over 9 bar significantly accelerate the wear of the neck and inner tubes.
Before starting work, the surface to be treated must be thoroughly vacuumed.
Do not leave the unit connected to the air line – use the convenient quick release coupling to disconnect when work is finished or a break is required.
In order to avoid uncontrolled spillage of the working solution during a break in the unit’s operation, the chemistry supply valve should be turned to the horizontal position.
During operation it is necessary to keep the inner surface of the neck clean. In case of contamination, lower the neck 5-7 cm into a container with water and remove the dirt by two-three short presses on the trigger.
After completion of all work, unscrew the neck and thoroughly rinse all working surfaces and elements with clean water.
The installation of an oil trap in the air line is recommended.
Technical specifications
Design features
Aluminum housing with plastic nozzle without bearings
